Introduction
This is a prerequisite to replacing any other piece. This guide involves removing most of the screws in the shell and splitting the gun along the middle seam.
Ce dont vous avez besoin
-
-
-
Pull slide back.
-
Pull backwards on release buttons and slide magazine out.
-
Push slide back forward and pull trigger.
Demander à FixBot
-
-
-
Use the Phillips #0 Screwdriver to remove these 9 screws.
-
All screws marked in red are 9.6 mm Phillips #0 screws.
-
Note that left most screw is longer than the rest and is a 18.6 mm Phillips #0 screw.
-
-
-
-
Pull slide back to reveal more screws.
-
Remove these 2 screws.
-
Push slide forward.
-
Pull trigger to release compression of the main spring.
-
Screws are 9.6 mm Phillips #0.
-
-
-
Remove the screws on the plunger cap.
-
Tug the plunger cap off.
-
Screws are 9.6 mm Phillips #0.
-
-
-
Remove the 2 screws on the slide.
-
Screws are 9.6 mm Phillips #0.
-
-
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
12 autres ont terminé cette réparation.
Équipe
Baylor, Team 8-14, Williams Fall 2014 Membre de l'équipe Baylor, Team 8-14, Williams Fall 2014
BU-WILLIAMS-F14S8G14
3 membres
6 tutoriels rédigés
2 commentaires de tutoriel
Does anyone have a spare spring for this gun I am missing mine
very useful, thanks!
