Introduction

Remove the front cover to access the lens mount, manual and autofocus switch, lens release switch, timer light, and other components.

Pièces

Aucune pièce nécessaire.

Retrieve your Pentax K200D, the lens mount cover, and required tools.
  • Retrieve your Pentax K200D, the lens mount cover, and required tools.

  • Remove the lens, if you have one attached, and replace it with the lens mount cover to make handling and repair easier.

Ajouter un commentaire

With the camera turned on, press the pop-up flash button to release the flash.
  • With the camera turned on, press the pop-up flash button to release the flash.

  • Be sure to turn the camera back off before proceeding.

  • Remove the two 4.3 mm Phillips screws securing the top edge of the front cover to the top cover.

What if you are disassembling the camera because it wont turn on. If you cant pop up the flash is there a work around?

Sean D99 - Réponse

  • Remove the seven 4.3 mm Phillips screws securing the bottom cover to the camera body

  • Remove the two 2.5 mm Phillips screws also securing the bottom cover to the camera body

  • Open the battery door and carefully remove the bottom cover, as the battery door components become unsecured when the bottom cover is removed.

Ajouter un commentaire

  • Remove the two 4.3 mm Phillips screws securing the right side of the front cover to the camera body.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

7 autre(s) ont terminé cette réparation.

Rick Nelson

Membre depuis le 05/06/2010

652 Réputation

1 tutoriel rédigé

Équipe

Master Techs Membre de l'équipe Master Techs

Community

277 membres

747 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 10

30 derniers jours : 37

Total : 3,721