Introduction

Multiple parts can easily break during disassembly. Proceed slowly with caution to avoid problems.

Pièces

Aucune pièce nécessaire.

Opening the device will void your warranty.
  • Opening the device will void your warranty.

  • Anti-slip pads cover three screws that hold the device together. Pry off the pads to access the screws.

  • Remove the three screws.

  • Save the pads for reassembly.

Ajouter un commentaire

Once the three screws are removed, the device is ready for disassembly.
  • Once the three screws are removed, the device is ready for disassembly.

  • Push up on the rear flap while holding down on the rest of the body. This will open a small gap.

  • Insert the plastic opening tool in the gap and begin prying on the corner.

  • Continue to pry around the body of the case. Separate both sides of the case with this method.

Ajouter un commentaire

  • Once the sides are released, the front of the cover can be removed.

  • Use a plastic opening tool to separate the front of the cover from the body.

  • It is helpful to use a different plastic opening tool as a wedge on the sides to prevent them from snapping back together.

Ajouter un commentaire

  • The cover can now be removed.

  • To repair anything on the circuit board, use the plastic opening tool to pull back on the two tabs holding it down.

  • Use caution when pulling on the tabs as they are stiff and easy to break.

  • Keep the tabs if they snap off. The tabs can be reattached with glue when reassembling the device.

Ajouter un commentaire

  • If the antenna needs to be disconnected, desolder the connection and reattach it prior to reassembly.

  • If the ethernet ports, power port, or reset button are damaged, the large solder points allow you to replace them.

  • Many components on the board cannot be serviced. These components were attached by a machine and cannot be removed.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

8 autre(s) ont terminé cette réparation.

Tahisha Hicks

Membre depuis le 24/02/2014

409 Réputation

4 tutoriels rédigés

Équipe

Michigan Tech, Team 5-4, Lauer Spring 2014 Membre de l'équipe Michigan Tech, Team 5-4, Lauer Spring 2014

MTU-LAUER-S14S5G4

3 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 10

30 derniers jours : 87

Total : 4,764