1. Orient the GPS V backside up.
    • Orient the GPS V backside up.

    • With a #0 Philips screwdriver, remove six M2x0.4 black screws on the back of the unit.

    Ajouter un commentaire

  2. CAUTION: With the spudger, gently pry the back plate off the unit starting at the corners.
    • CAUTION: With the spudger, gently pry the back plate off the unit starting at the corners.

    • As you open the unit, locate the 8-pin white connector on the logic board and disconnect it. The antenna side of the device should act like a hinge as you open it.

    • Open the device all the way, making sure to not disconnect the brown antenna wire.

    Ajouter un commentaire

    • With a #1 Philips screwdriver, remove the silver M2x0.4 screw on the logic board near the brown wire.

    • NOTE: You may need to rotate the device to get better access to the screw.

    Ajouter un commentaire

    • Locate the ribbon connector on the logic board.

    • With the spudger, gently apply pressure to both sides of the brown connector lock until it pushes out.

    • With the spudger, gently work the ribbon cable out of the connector until it is free.

    Ajouter un commentaire

    • CAUTION: With the spudger, gently pry out the logic board.

    • NOTE: Be careful to not disconnect the brown antenna wire as you remove the logic board.

    Ajouter un commentaire

    • Locate the brown wire connection on the logic board.

    • CAUTION: Carefully apply heat with the soldering iron while gently pulling on the brown wire.

    • NOTE: It may take some time to heat the flux up before the wire can be pulled out.

    • Pull brown wire free of the logic board.

    Ajouter un commentaire

    • Gently pry the button pad off of the front plate.

    Ajouter un commentaire

    • Orient the front plate of the device so the display board is facing up.

    • With the spudger, gently work your way around the display assembly.

    • NOTE: The display assembly is composed of three parts and is glued to the case. Be careful to not separate it when prying it out.

    • Pry the display free of the front plate.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Connor

Membre depuis le 23/01/2012

166 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 3-25, Amido Winter 2012 Membre de l'équipe Cal Poly, Team 3-25, Amido Winter 2012

CPSU-AMIDO-W12S3G25

4 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 22

Total : 2,896