Introduction
The exterior component of the NutriBullet’s powerbase consist of a silver, plastic shell casing. Use this guide to replace the cylindrical shell to ensure no leakage, exposure of wires or spinning components are showing through.
Ce dont vous avez besoin
-
-
Unplug the device from the wall and turn the powerbase upside down.
Demander à FixBot
-
-
-
Use a #2 Phillips Head Screwdriver to unscrew the four 10 mm screws located on the bottom of the power base.
-
-
-
Use slight tension to remove the plastic base from the NutriBullet once all of the screws are removed.
-
-
-
-
Lift the power cord to remove it from the side slot on the curved base.
-
-
-
Use a #2 Phillips Head Screwdriver to remove the two 10 mm screws that secure the white bracket down.
-
-
-
Use a #2 Phillips Head Screwdriver to remove the three 10mm screws that keep the base in place.
-
-
-
Use slight tension to remove the curved base by lifting it upward off of the outside casing.
-
-
-
Wiggle the outside casing upward until it separates from the powerbase.
-
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
5 autres ont terminé cette réparation.
Équipe
Cal Poly, Team 19-8, Maness Winter 2015 Membre de l'équipe Cal Poly, Team 19-8, Maness Winter 2015
CPSU-MANESS-W15S19G8
4 membres
19 tutoriels rédigés
4 commentaires de tutoriel
Ok so what happens after Step 8 of pulling the Nutribullet apart? Did I miss something?? Now I have my Nutribullet in pieces on the benchtop. Now what??
So what happens next? What is one suppose to do? Stupid help, I would say
I tried step number 8 and the outside casing still won't slide off. What do I do now?
