Pour réparer ensemble - Je crée un compte

Introduction

LCD screens are known to shatter when dropped. In this guide you will replace the LCD screen that is on the inside of the camera.

Ce dont vous avez besoin

Remove the two visible 6.0 mm Philips #0 screws on the left and right sides of the viewfinder. These screws are highlighted in red.

Demander à FixBot

Remove the four 6.0 mm Philips #0 screws on the left and right sides of the camera.

Demander à FixBot

Remove the four highlighted 3.0 mm Philips #0 screws on the bottom of the camera.

Demander à FixBot

While pulling the bottom down, remove the back of the camera.
Be careful not to pull too hard on the back as it is connected via a ribbon cable. Be sure to disconnect this cable on the main board.
To disconnect the ribbon cable pull the small black tab upward and pull gently on the cable.

Demander à FixBot

Remove the six 3.0 mm Philips #0 screws on the inside of the back panel which contains the LCD screen.

Demander à FixBot

Demander à FixBot

Remove the metal casing containing the LCD screen using the plastic opening tool.
Be sure to look at the picture to make sure you are removing the correct piece of metal. There should be no glue holding the correct piece to the frame.