Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
If your laser is plastic: You must replace the laser due to uneven wear.
-
If you have a Die cast laser, this fix may improve the read rate. However, this is an age based failure. Note: In some cases, the laser resistance will need to be adjusted.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the 6 screws from the bottom of the PlayStation. Use a Phillips #2 screwdriver.
-
Lift the top cover off.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
With the laser removed from the system, remove the 2 Phillips PH1 screws. Check if the laser is plastic.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Before starting, mark the original adjustment point and write down the factory setting as tested. It will be difficult to take it back to stock without this information.
-
Adjust the trimpot incrementally using a Phillips PH1 or other compatible bit. Do this until the laser is reading games more consistently.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Partially reassemble the system and test it. If it is sufficient, reassemble the system.
-
To test the read percentage, get a few known good games and see which ones load. A minimum of 5 test games is recommended. Only adjust the laser again after each full test is done.
-
If the game loads, test play the system for a few minutes to check the stability. Important: Some early revisions have FMV issues - THIS IS EXPECTED.
-
Annulation : je n'ai pas terminé ce tutoriel.
4 autres ont terminé cette réparation.
3 commentaires
Hello, I recently attempted to replace my weak laser in my 5501 with a 440BAM and it did not work, I even tried putting back the old laser but it wouldn't work again at all no motor spin or anything. Any ideas as to what I'm doing wrong or how to fix? Thanks!