Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove all traces of adhesive and debris from the phone's frame. Clean the adhesion surface with high concentration isopropyl alcohol (over 90%) and wipe it clean with a lint-free cloth.
-
Peel off the clear plastic backing from the pre-cut adhesive strip, exposing one side of adhesive.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully line up an edge of the adhesive with the corresponding edge of the phone frame. Make sure the adhesive is properly oriented.
-
Set the adhesive down lightly on the frame.
-
Make sure that the adhesive cutouts match the phone, and that the camera and sensors are not covered by adhesive.
-
If it is not properly aligned, carefully peel the adhesive back up.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Once the adhesive is aligned on the frame, run the flat end of a spudger around the perimeter of the adhesive to press it into place. You can also use your fingers.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Continue reassembling your device until you are ready to attach the screen.
-
Peel and remove the green plastic liner from the adhesive strip to expose the screen-facing adhesive.
-
Align and set the phone screen on top of the adhesive.
-
Use your fingers to squeeze around the perimeter of the phone to set the adhesive.
-
Apply a few books worth of weight on top of the screen for an hour to help the adhesive bond.
-
Annulation : je n'ai pas terminé ce tutoriel.
13 autres ont terminé cette réparation.
