Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Here is the assembled throttle cable. It seems to be assembled correctly, but certainly does not function properly.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
The throttle parts.
-
The only logical way for me to assemble these parts were:
-
Insert needle into gold-colored cylinder.
-
Insert retaining clip on top of needle.
-
Then compress and insert the spring (see following steps on how the spring was inserted).
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
To assemble the throttle cable:
-
I first use a pair of needle-nose pliers to compress the spring as much as I can.
-
This allows me to insert the throttle cable into the gold-colored cylinder without having to meddle with the spring too much.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
I attach the throttle cable to the bottom of the gold cylinder and then route it through the cylinder's side slot.
-
The alternate view (picture 2) shows how everything looks internally.
-
After the throttle cable is in place, I let go of the spring into the cylinder.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the gray cap. As you can see, the spring compresses, and the throttle cable pops outward.
-
When I twist the moped's throttle, the throttle cable goes inwards. I believe this is the desired action for the cable.
-
There are two problems, however:
-
Nothing pushes the throttle cable back out when I release the moped's throttle.
-
The throttle needle does not move, but to my understanding it should go upward when I apply the throttle.
-
Please check out my Answers question if you can help me solve this problem! Thanks a lot!
-
