Introduction

Use this guide to replace the RAM.

The processor in the DS412+ supports DDR3 800/1066MHz RAM modules

DS412+
  • DS412+

  • Open the front pannel

Ajouter un commentaire

Remove the hard disks
  • Remove the hard disks

Ajouter un commentaire

  • Remove those 2 screws

Ajouter un commentaire

  • Locate those 2 tabs

  • Lift them up off the metal brace

This step could really use a better illustration of the removal technique. The plastic here is extremely stiff and it can be hard to bend it enough to move the tabs.

This is the best technique I found, that will avoid damaging the plastic facing of the case. I am using the iFixit photo as a guide. Take a flathead screwdriver and place it down within the DS412, head facing up. Stick the head in between the metal bar and the plastic casing, and at the midpoint between the two tabs. Apply gentle pressure.

Chris - Réponse

  • Push the case away

  • It should look like this

Ajouter un commentaire

  • Lift the case up

  • Remove the case

Ajouter un commentaire

  • Remove this screw

Ajouter un commentaire

  • Remove this screw

Ajouter un commentaire

  • Remove those 4 screws

Ajouter un commentaire

  • Pull the fan a little bit away

Ajouter un commentaire

  • Watch out for this plug

  • Lift the metal bracket out

Ajouter un commentaire

  • Remove the fan power cords

Ajouter un commentaire

  • Remove the circuit board

Ajouter un commentaire

  • Remove those 4 screws

Ajouter un commentaire

  • Lift out the circuit board

Ajouter un commentaire

  • Pull these tabs and remove the ram

  • Old and new Ram

  • To reassemble your device, follow these instructions in reverse order.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

21 autre(s) ont terminé cette réparation.

gieljnssns

Membre depuis le 26/06/2011

621 Réputation

1 tutoriel rédigé

Hi is it also possible with a Synology ds216play? Or is the RAM not modular in this Drives?

markusguenther30684 - Réponse

Very nice guide. Thank you!

mbs - Réponse

Thank you for the guide, just to ease it up a bit for everybody following, the best way to pull the two tabs from step 4 was to use small spoon (or anything metal) and use it as a crowbar from the inside (do not try to put force from the outer rim, but really from inside of the Synology itself (against the metal beam the tabs are holding to).

Ondrej Palat - Réponse

Thank you very much.

Olivier Claude - Réponse

did these steps and now my DS412+ won't boot anymore. just the blue power light for a few seconds, no hard drive or fan will turn on.

after putting the old RAM in the slot nothing changed. cannot find any error, how do I find out what's wrong here???

Andreas Hanny - Réponse

Super facile, en 10 minutes même pas c'est fait !!

user0 - Réponse

This guide was great. Thanks for posting it!

I upgrade to 2gb RAM last night with no problems. I used "Kingston Technology ValueRAM 2GB 1333MHz DDR3 Non-ECC CL9 SODIMM SR X16 Notebook and Portable Memory KVR13S9S6/2" from Amazon.

System is humming along nicely now.

Jeff Smith - Réponse

Thank you for this guide.

I upgrade my RAM without any trouble.

The use of two tea spoon to lift the tab in step 4 is very useful.

Marc Jean - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 8

7 derniers jours : 36

30 derniers jours : 187

Total : 9,095