Aller au contenu principal
Pour réparer ensemble - Je crée un compte

iBook G3 12" Keyboard Replacement

Ce dont vous avez besoin

    1. iBook G3 12" Keyboard Replacement, Battery: étape 1, image 1 de 1
      • Use a coin to rotate the battery locking screw 90 degrees clockwise.

      • Lift the battery out of the computer.

      Demander à FixBot

      Ajouter un commentaire

    1. iBook G3 12" Keyboard Replacement, Keyboard: étape 2, image 1 de 1
      • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

      • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

      • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

      Demander à FixBot

      Ajouter un commentaire

    2. iBook G3 12" Keyboard Replacement: étape 3, image 1 de 1
      • If the computer does not have an Airport card installed, skip the next two steps.

      • Push the wire clasp toward the Airport card and pull it up to free it from the RAM shield.

      Demander à FixBot

      Ajouter un commentaire

    3. iBook G3 12" Keyboard Replacement: étape 4, image 1 de 1
      • Grasp the clear plastic tab on the Airport card and pull toward the right.

      Demander à FixBot

      Ajouter un commentaire

    4. iBook G3 12" Keyboard Replacement: étape 5, image 1 de 1
      • Hold the Airport card in one hand and use your other hand to remove the antenna cable.

      Demander à FixBot

      Ajouter un commentaire

    5. iBook G3 12" Keyboard Replacement: étape 6, image 1 de 1
      • Remove the two 2.5 mm Phillips screws that secure the RAM shield.

      Demander à FixBot

      Ajouter un commentaire

    6. iBook G3 12" Keyboard Replacement: étape 7, image 1 de 1
      • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

      Demander à FixBot

      Ajouter un commentaire

    7. iBook G3 12" Keyboard Replacement: étape 8, image 1 de 1
      • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

      Demander à FixBot

      Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Annulation : je n'ai pas terminé ce tutoriel.

17 autres ont terminé cette réparation.

Pièces jointes

iRobot

Membre depuis le 09/24/09

1 Réputation

636 tutoriels rédigés

0 commentaires de tutoriel

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 9

30 derniers jours : 50

Total : 11,487