Introduction

One RAM slot will accept PC100 or PC133 chips up to 512 MB.

Use a coin to rotate the battery locking screw 90 degrees clockwise.
  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  • Lift the battery out of the computer.

Ajouter un commentaire

Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.
  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

  • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

  • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

Ajouter un commentaire

  • If the computer does not have an Airport card installed, skip the next two steps.

  • Push the wire clasp toward the Airport card and pull it up to free it from the RAM shield.

Ajouter un commentaire

  • Grasp the clear plastic tab on the Airport card and pull toward the right.

Ajouter un commentaire

  • Hold the Airport card in one hand and use your other hand to remove the antenna cable.

Ajouter un commentaire

  • Remove the two 2.5 mm Phillips screws that secure the RAM shield.

Ajouter un commentaire

  • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

Ajouter un commentaire

  • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

Note: The cable may have adhesive holding it to a shield. Pull in an upward direction gently, with an evenly distributed force across the cable until it comes loose from the shield.

gsp - Réponse

I feel this step needs clarification: Are just lifting the cable away from the shield, or are we removing the cable entirely?

David Maag - Réponse

  • Your laptop should look approximately like this.

Ajouter un commentaire

  • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

  • Pull the chip directly out from its connectors.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

44 autre(s) ont terminé cette réparation.

Pièces jointes

iRobot

Membre depuis le 24/09/2009

1 Réputation

774 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 20

Total : 31,780