Aller au contenu principal

Introduction

Battery not lasting long? Swap it out.

Pièces

  1. Before opening your iPod, ensure that the hold switch is in the locked position.
    • Before opening your iPod, ensure that the hold switch is in the locked position.

  2. Opening the iPod can be challenging. Don't get discouraged if it takes a few tries before the iPod is opened.
    • Opening the iPod can be challenging. Don't get discouraged if it takes a few tries before the iPod is opened.

    • Insert a plastic iPod opening tool in the seam between the white plastic front and metal back of the iPod. Once you've inserted the tool, run it along the seam to free the five tabs holding the iPod together.

  3. Continue to run the opening tool along the side of the case until all five tabs have been released.
    • Continue to run the opening tool along the side of the case until all five tabs have been released.

  4. Work around the corner of the iPod and release the two tabs holding the iPod together near the dock connector.
    • Work around the corner of the iPod and release the two tabs holding the iPod together near the dock connector.

  5. Batteries pour ordinateurs portables

    Batteries pour toutes les grandes marques d'ordinateurs portables. Qualité assurée par notre garantie.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Batteries pour toutes les grandes marques d'ordinateurs portables. Qualité assurée par notre garantie.

    Acheter maintenant
  6. Free the five tabs holding the iPod together on the other side. You may be able to free the tabs by gently wiggling the front panel of the iPod.
    • Free the five tabs holding the iPod together on the other side. You may be able to free the tabs by gently wiggling the front panel of the iPod.

  7. Lift the rear panel away from the iPod, making sure it doesn't catch on the headphone jack.
    • Lift the rear panel away from the iPod, making sure it doesn't catch on the headphone jack.

  8. Peel up the metallic tape attached to the top of the battery.
    • Peel up the metallic tape attached to the top of the battery.

  9. Lift the battery up from the hard drive and lay it next the the iPod (it is still connected to the logic board).
    • Lift the battery up from the hard drive and lay it next the the iPod (it is still connected to the logic board).

  10. Lift up the end of the hard drive near the Firewire port to allow easy access to the battery connector.
    • Lift up the end of the hard drive near the Firewire port to allow easy access to the battery connector.

  11. Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.
    • Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.

Conclusion

To reassemble your device, follow these instructions in reverse order.

12 autre(s) ont terminé cette réparation.

iRobot

Membre depuis le 24/09/2009

1 Réputation

624 tutoriels rédigés

Nice easy fix. Modern batteries are twice the capacity too. These old gen iPods are great. Nice to have an apple product not made in China.

peter barker - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 9

7 derniers jours : 20

30 derniers jours : 86

Total : 21,245