Introduction

Replace a cracked or faulty display.

Pièces

Aucune pièce nécessaire.

Before opening your iPod, ensure that the hold switch is in the locked position.
  • Before opening your iPod, ensure that the hold switch is in the locked position.

Ajouter un commentaire

Opening the iPod can be challenging. Don't get discouraged if it takes a few tries before the iPod is opened.
  • Opening the iPod can be challenging. Don't get discouraged if it takes a few tries before the iPod is opened.

  • Insert a plastic iPod opening tool in the seam between the white plastic front and metal back of the iPod. Once you've inserted the tool, run it along the seam to free the five tabs holding the iPod together.

Ajouter un commentaire

  • Continue to run the opening tool along the side of the case until all five tabs have been released.

Ajouter un commentaire

  • Work around the corner of the iPod and release the two tabs holding the iPod together near the dock connector.

Ajouter un commentaire

  • Free the five tabs holding the iPod together on the other side. You may be able to free the tabs by gently wiggling the front panel of the iPod.

Ajouter un commentaire

  • Lift the rear panel away from the iPod, making sure it doesn't catch on the headphone jack.

Ajouter un commentaire

  • Peel up the metallic tape attached to the top of the battery.

Ajouter un commentaire

  • Lift the battery up from the hard drive and lay it next the the iPod (it is still connected to the logic board).

Ajouter un commentaire

  • Carefully disconnect the orange ribbon cable from the hard drive.

  • If the cable doesn't come free easily, it may be helpful to gently wiggle the cable from side to side.

  • Lift the hard drive out of the iPod.

Ajouter un commentaire

  • For the following step, you only need to move the locking bar about 2 mm. Pushing too hard or too far will damage the connector.

  • Loosen the connector by pulling the brown locking bar toward the hard drive cable using the tips of your fingers.

Ajouter un commentaire

  • Slide the hard drive cable out of its connector.

Ajouter un commentaire

  • Lift the blue hard drive mounting bracket out of the iPod.

Ajouter un commentaire

  • Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.

Ajouter un commentaire

  • Like the hard drive connector, for the following step, you only need to move the connector about 2 mm. Pushing too hard or too far will damage the connector.

  • Loosen the touch wheel connector by pulling the brown locking bar toward the side of the iPod using the tips of your fingers.

Ajouter un commentaire

  • Remove the 8 T6 Torx screws from the logic board.

Ajouter un commentaire

  • Lift the logic board up enough to disconnect the orange touch wheel cable.

  • Lift the logic board out of the iPod.

Ajouter un commentaire

  • Note the location of the four white plastic tabs securing the display to the logic board. These tabs must be released before the display can be removed.

Ajouter un commentaire

  • Use a spudger or your finger to free the four white plastic tabs indicated in the previous picture.

Ajouter un commentaire

  • Use a spudger to carefully disconnect the display ribbon cable from beneath the scroll wheel.

  • Lift the display off the logic board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

iRobot

Membre depuis le 24/09/2009

1 Réputation

774 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 2

Total : 6,394