Introduction
The brush module on the roomba does the majority of the cleaning and it can easily get tangled in various household fibers such as hair causing it to stop turning. When this happens it is necessary to remove the module and clean it as outlined in the troubleshooting section.
Ce dont vous avez besoin
-
-
-
Flip over the device and remove the two 11.5 mm screws using the Phillips #1 screwdriver.
Demander à FixBot
-
-
-
Unscrew the back plate using a Phillips #1 screwdriver.
-
Carefully lift the panel up once the screws are removed.
-
-
-
With both hands, grab the two black tabs on each end of the battery.
-
Pull the tabs upwards to remove the battery.
-
-
-
-
-
-
Press down on the button on the rear of the device.
-
Pull bin towards you to remove it.
-
-
-
Loosen the screw holding the side brush in place.
-
Lift the side brush.
-
-
-
Remove the (2) 11.5mm Phillips #1 screws holding down the bottom plate.
-
Carefully lift the bottom plate.
-
-
-
Remove the (4) 15.8mm Phillips #1 gold screws around the brush module.
-
-
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
3 autres ont terminé cette réparation.
Équipe
USF Tampa, Team S14-G2, Boczar Fall 2017 Membre de l'équipe USF Tampa, Team S14-G2, Boczar Fall 2017
USFT-BOCZAR-F17S14G2
4 membres
14 tutoriels rédigés
