Traduction de l’étape 14
Étape 14
Unscrew the left circuit board
-
Unscrew the left circuit board. Note: Mine had spots for 7 screws but only six were installed. Might not mater but I took a picture and made sure to put the screws back in the same holes.
-
The second picture shows two plastic tabs that have to be pressed towards each other to release the board. The tabs are far enough apart that I could press one at a time while lifting that side of the board.
-
Once the left board is loose change all the switches and check the alignment (listen for the click, same as the last board).
-
Trim the excess lead length.
-
Once all switches work screw the board back down and listen for clicks one last time.
Vos contributions sont faites dans le cadre de la licence open source Creative Commons.