DouglasVinicio

Am i the only one or are you guys encoutering some problems with iPhone 7 LCD also? Now i’m removing the low retaining...

Is it the Touch Screen flex cable that is on the way preventing to proper assembly? If yes, they go “hidden” behind the LCD and a little part goes hidden “inside” the chassis. Is tricky and very hard to explain in words how to do it. I would recommend to look up for some videos “iPad Mini 3 Screen Replacement” and attention to details, this is the most important one. Good luck!

Have you checked for Blacklist / IMEI issues? If not, go to the website - https://www.devicecheck.ca/check-status-device-canada/ It says Canada but is valid worldwide. I would check before even disassembly my phone. Good luck!@

Maybe it is your SIM Card. Have you tried another one?

Have you tried a new chargin port? If yes and didn’t work you should start worry about your motherboard. Charging ic maybe.

iPhone 6s Plus LCD and Digitizer Yes it is. If you’re looking for a less expansive you can on Ebay,Amazon or chinese websites. But take care to not buy poor quality no garanty LCD’s. Good luck.

First of all did you try force restart your device? If not here’s a link showing you how to : https://support.apple.com/en-ca/guide/iphone/force-restart-iphone-iph8903c3ee6/ios Maybe you wanna try to restore your iOS also with iTunes or 3uTools before. If it doesn’t work it could be : 1 - Your Touch Screen that just sudenly stopped to work . 2 - Your motherboard (Touch iC - Cumulus or Meson ). 3- Some FPC connector or failing component. Good luck,

O aparelho caiu? Molhou? Ja testou uma nova bateria? Possui multimetro pra medir a voltagem? Poste mais detalhes do seu problema para que possamos tentar te ajudar.

Probablement pas vu que la plupart des écrans Samsung ont déjà de la colle. Mais c’est un cas de jugement,si vous remarquez que la colle/adhésif que viens d’origine n’est pas assez fort ajoutez de la b7000 et laissez sécher pendant quelques minutes.

I would try another shop specialized in microsoldering and iPhone’s. It is something that you did while switching housing. It could be a lot a things,Audio IC,Tristar or Tigris,Home Button. What you need is a good and specialized microsoldering guy that will find the right component that need to be replaced. Good luck,

Yes! It’s the same touch screen (Glass) that we use for the iPad Air 1 Generation. The only difference is the Home Button,so be attentive to not damage your Touch iD home button and good luck.

Nice to have more FPC connectors.