Ethan Leroux

Hey guys! I'm having an issue with my 2000 Honda accord. When the lights are off, the turn signals operate normally. As...

Hey, I bought a surface pro 5 from a recycler. Turned out to work fine but was password locked. I wiped the drive in linux...

Hey folks, this is going to be a long one. So a while back I decided to start dabbling into micro-soldering. Not going as...

Hey guys. So a few hours ago I spilled a small amount of water on my MacBook. I had the bottom case open as I was...

Hey all So i’ve recently started messing around with microsoldering. I’ve mostly been practicing on dead or iCloud...

There’s nothing actually wrong with my phone. I’m just wondering if there’s a way to get it to verbose boot automatically?...

Hey guys So I recently bought a cracked iPhone 8 with the intention of fixing it and flipping it. When I checked it out...

Hey all, so recently the charger for my Razer Blade 14 broke… The only replacement ones that match this computer’s old one...

When the laptop shut off, i was doing some light gaming while listening to a podcast. It was on a bed, so cooling probably...

Hey all. I recently bought a live demo unit galaxy s8 plus. I tried to flash normal software on it thru odin. That passed...

Update: I've replaced the switch to no avail. The culprit was a bad ground above the drivers side kick panel. One of the wires had broken lose and I didn't notice it until I followed a wiring diagram and saw one wire was missing. Found it shoved up into the wire sleeve. So, for anybody facing a similar issue, before you jump to replacing parts, double check all your grounds are intact. That solved my issue immediately.

It should be fine. I’ve done it with tonnes of my phones without any issues

Chances are its from apples terrible design of having ALL the hot air from the cpu and gpu blowing on the hinge glue. Not your fault. Put some new epoxy and it should be fine

I had this exact same issue with my iphone 5c. Put the phone is DFU mode and do a itunes restore. Its a software bug

Whats wrong with it? we need to know before we can tell you what to do...

If you remove the back glass again will it power on? It is plausible that your adhesive may have got onto the motherboard and is shorting something? although not many adhesives are conductive.

It will not hurt anything. Just try not to touch the lcd itself or the mainboard while the ipad is on.

You will need to replace the entire LCD assembly. You have cracker the main LCD under the glass. https://www.amazon.ca/Eaglestar-Digitizer-Assembly-Faceplate-5-Silver/dp/B0755D8BW3/ref=sr_1_6?ie=UTF8&...-6&keywords=lg+aristo+lcd

Unfortunately, the dock connectors are completely different.

did you COMPLETLEY turn the power off? Like shut down? In the morning was the phone turned on?

Where can you get a battery?