Outils recommandés dans ce démontage

Introduction

This tear down includes a complete photographic guide for the removal of all internal components of a RIM Blackberry 8700c.

Cette vue éclatée n'est pas un tutoriel de réparation. Pour réparer votre BlackBerry 8700c, utilisez notre manuel de réparation.

In this first step you will remove the battery cover by pushing down on the button on the cover and sliding towards the bottom of the phone.
  • In this first step you will remove the battery cover by pushing down on the button on the cover and sliding towards the bottom of the phone.

    • To do this unscrew all four T6 screws

    • Once this is done gently remove the back cover of the phone by pulling first from the bottom towards you, then from the top upwards.

Ajouter un commentaire

To remove the battery, place your fingernail in the slot at the top right of the battery and pull up.
  • To remove the battery, place your fingernail in the slot at the top right of the battery and pull up.

Ajouter un commentaire

  • Next, remove the back portion of the phone by removing four T6 Screws.

  • Once the screws have been removed, firmly grab the back cover and pull back from the front cover.

Ajouter un commentaire

  • To remove the middle portion of the phone you will again remove four T6 screws.

  • Follow the removal of the screws, you can now pull the front face plate away from the middle portion.

Ajouter un commentaire

  • Follow the removal of the screws, you can now pull the middle portion away from the main logic board.

  • Next, hold the logic board and remove the front face plate of the phone

Ajouter un commentaire

  • When the front face plate has been pulled away, be sure to grab the keypad as it may fall out.

Ajouter un commentaire

  • Next, use a metal spudger to unhook the earpiece from the inside of the front panel.

Ajouter un commentaire

  • Using a metal spudger, push back on the four clips holding the LCD screen to the logic board.

    • Next gradually pull the screen away from the board so that none of the clips are engaged.

  • Last, use a metal spudger to push back on the clip locking in the ribbon cable for the screen.

Ajouter un commentaire

  • The screen is now fully detached, and the phone is completely disassembled.

Ajouter un commentaire

k3nt

Membre depuis le 28/10/2009

42 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 18-4, Maness Fall 2009 Membre de l'équipe Cal Poly, Team 18-4, Maness Fall 2009

CPSU-MANESS-F09S18G4

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 6,227