Aller au contenu principal

Réparez vos affaires

Droit à la réparation


iPhone 4 pouces commercialisé depuis mars 2016 avec une configuration de matériel similaire à l'iPhone 6s. Disponible en Argent, Gris sidéral, Or ou Or Rose, avec 16 ou 64 Gb de stockage. Modèles A1662 et A1723.

Questions au sujet de 893 Voir tout

After repairing screen phone will not charge past one percent.

I replaced the screen on a friends iPhone SE, and afterwards noticed that it would not charge past one percent. Thought it perhaps was a software issue since it was still on iOS 9. Did a restore to 10.3.3 and it magically went to 44% but would not go past that. I ordered a new battery, hoping that was the issue but when I connect the new battery it doesn't go past 3% now. Have tried another restore but no luck. I've seen on here that at least one person had to have their board repaired to fix it. Any suggestions?

The phone has no water damage and was in great condition other than the cracked screen. I have repaired thousands of iPhones so I do not believe it was my error. I disconnected the battery before replacing the screen.

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Indice 0
Ajouter un commentaire

2 solutions

Solution retenue

Did you try putting the old screen back on the device? It is possible the new screen is drawing too much power and messing the power-regulation that the iPhone traditionally employs with the components. I've seen some low-quality or defective screens cause power fluctuations in the device in the past that was only resolved by replacing said screen.

It is also possible that the device is experiencing Tristar disease. Repair shops have been inundated with these issues as of late. It's caused by using non-Certified charging cables and accessories that power through the lightning port. It's pretty hard to tell without a full-on teardown of the cable (that would break it, obviously) but a good rule of thumb is if the cable cost less than $5 and came from a gas station, it's not a certified cable. Certified Cables, or mFI cables, employ a U2 chip that regulates power like a surge protector. If this is the case the phone will need board level repair on that chip to be up and running again.

Cette réponse a-t-elle été utile ?

Indice 1


I have not tried putting the original screen on it to see as it's broken pretty bad but it's worth a shot. I'm afraid it might be the tristar issue you mentioned.


ok. i will agree with @cvneutron on the fact that it might be the screen. otherwise not. because i bought a fake battery before and it never increase but decreasing. one repairer was already suggesting its the charging port but i disagreed. so i put back the old Battery and it work just fine.

only that the old battery don't last long.

but in your case. only if you can try those Battery on other device. we can rule that out and start from there.


it ended up being the tristar power management component. user did not want to spend $ for additional repair since it was a free phone


Ajouter un commentaire

i'm sure it's bad Battery. the only way to rule that out is if the batteries can perform well from another iPhone.

until then get original Battery. there are way too much fake Battery in markets

Cette réponse a-t-elle été utile ?

Indice 0


I did actually try a brand new battery from a reputable supplier.


Ajouter un commentaire

Ajouter une réponse

Chris k sera éternellement reconnaissant.
Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 98