Rep: 13
2
I replaced the screen on my Apple Watch using the kit that included the force touch sensor in January. Everything was working fine. Recently (July) the screen came loose. The touch sensor is coming loose on both surfaces. The battery does not look bloated. It seems the adhesive is defective. What do I do now?
Cette question est-elle utile ?
Rep: 480,1k
35
329
971
You’ll need to get fresh adhesive Remplacement de l'adhésif de l'Apple Watch or the full Remplacement du capteur Force Touch de l'Apple Watch
What likely happened is the surfaces were not clean enough. Either old adhesive was present or the solvent you use to clean the surface left a film which prevented good adhesion.
Sun screen and bug sprays can soften the adhesive so make sure you don’t get it on the watch.
Tutoriel
Difficulté :
Modérée
—
1 - 2 hours
Tutoriel
Difficulté :
Difficile
—
1 - 2 hours
Cette réponse est-elle utile ?
If the force touch sensor is loose on both surfaces, can you still do the adhesive replacement? The guide shows the force touch still attached to the watch body and the adhesive being applied on the display side.
Its a sandwich: adhesive - sensor - adhesive
Its a matter on what failed the display side. or the case side, or both!
I bought a new force touch sensor from ifixit. I cleaned the surfaces of the watch body and screen scrupulously using isopropyl alcohol.
There was absolutely no residue on the surfaces. I even used disposable gloves to prevent skin oils from contaminating anything. After installing the new force touch sensor, I wrapped it in rubber bands and let it sit overnight.
The next day after wearing it for about three hours, the screen started to come off again.
What was the grade of the isopropyl alcohol?
Did you contact the iFixit store to see what they said?
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 2
Total : 196
