Four slicer failed mid cycle both sides loaded
What component failed to konk out both sides simultaneously Mid cycle?
Cette question est-elle utile ?
Indice
0
650786
1 Réponse
Solution retenue
Rep: 449,3k
11
366
1,4k
Hi @beaualta ,
Could be any one of several components, thermostat, fuse, switches etc. Anywhere where the power goes through to get to all of the heater elements
Check the control board for any obvious damage i.e. burnt out or heat stressed components etc.
Here’s the ifixit Cuisinart CPT-140BK Circuit Board Replacement guide that should help.
If you spot any damage or even if not, post some close up images back here of the component side of the circuit board. Here’s how to do this Ajout d'images à une question existante
Tutoriel
Ajout d'images à une question existante
Difficulté :
Très facile
—
2 - 5 minutes
Tutoriel
Cuisinart CPT-140BK Circuit Board Replacement
Difficulté :
Modérée
—
20 minutes
Cette réponse est-elle utile ?
Indice
0
I’m actually dug into a DeLonghi but think the issue could be universal to any brand. Thanks for the assistance
Thanks @jayeff
