Aller au contenu principal

Introduction

SD board prerequisite guide.

  1. Remove the two 4.5 mm Phillips screws securing the SD board to the motherboard.
    • Remove the two 4.5 mm Phillips screws securing the SD board to the motherboard.

  2. Use the flat end of a spudger to pry the SD board ribbon cable connector off its socket on the motherboard. Use the flat end of a spudger to pry the SD board ribbon cable connector off its socket on the motherboard.
    • Use the flat end of a spudger to pry the SD board ribbon cable connector off its socket on the motherboard.

  3. Insert the flat end of a spudger between the SD board and the motherboard. Run the spudger along the sides of the SD board to free it from the adhesive pad holding it in place. Once completely freed, lift the SD board straight off the motherboard.
    • Insert the flat end of a spudger between the SD board and the motherboard.

    • Run the spudger along the sides of the SD board to free it from the adhesive pad holding it in place.

    • Once completely freed, lift the SD board straight off the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

David Hodson

Membre depuis le 13/04/2010

137 025 Réputation

127 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 196