Beats Pill XL 'b' Button Replacement

Alejandro Velez et 3 autres contributeurs

Dernière mise à jour le June 17, 2015

15 - 20 minutes

Facile

Introduction

Involves opening the case, removing ribbon cable from motherboard, removing four screws, prying off the 'b' button from the hardware and replace with new 'b' button.

Ce dont vous avez besoin

Outils

Afficher plus…

iFixit touche une commission lorsque vous achetez par l'intermédiaire de ces liens.

Étape 1 Case

Beats Pill XL 'b' Button Replacement, Case: étape 1, image 1 de 2

Beats Pill XL 'b' Button Replacement, Case: étape 1, image 2 de 2

Using a plastic opening tool, pry the casing from the rest of the device.
Pry all the way around the edge and then pull apart.
It should be relatively easy, to pull apart. Don't be afraid to apply a necessary force.

Traduire

Étape 2

Using your thumb, remove the 8 rubber plugs in order to get to the screws.
Simply rub them towards the speakers and they will slide out enough to grip the edge and pull them out.
In the picture provided, we labeled four of them on one side of the Beats Pill XL. The other four are symmetrical to these four on the other side of the device.

Traduire

Étape 3

Using a Phillips #2 screwdriver, remove the 8 (10mm maxi-loc Phillips #2) screws that hold the casing together.

Traduire

Étape 4

Pull apart the front casing from the back casing, slowly. Try to avoid any tension on any of the connected cables.
Separate at a slow constant force to avoid damage to the ribbon cables.

Traduire

Étape 5

Gently pull on the plastic tab at the base of the ribbon cable to remove it from the motherboard.
Never pull the cables by the cord, as this could cause damage to the cables and/or motherboard. Always disconnect the cables from the base by the motherboard.

Traduire

Étape 6

Using your thumb and index finger, pull upwards on the base of the the power cable to remove it from the motherboard.
Even though there are two batteries, there is only one cable connecting the two to the motherboard.

Traduire