Introduction

Follow this guide to remove the riser main slider in order to repair or replace it.

Outils

Aucun outil requis.

Pièces

Aucune pièce nécessaire.

  1. Test pump performance by pumping 40 strokes.
    • Test pump performance by pumping 40 strokes.

    • An effective pump should return at least 10 liters.

    Ajouter un commentaire

  2. Remove the two pins connecting the handle to the slider.
    • Remove the two pins connecting the handle to the slider.

    Ajouter un commentaire

    • Pull the two lever arms away from the slider.

    Ajouter un commentaire

    • Lift the two pins attaching the pump frame to the head and handle up, off of the pump frame.

    Ajouter un commentaire

  3. Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    • Throughout this step, make sure you support the handle and head with at least three hands.

    • Slide the bearing rod out of the head.

    • Inspect the bearing rod and head for any wear or tear.

    Ajouter un commentaire

    • Remove the head and handle, and place them on a clean surface to prevent contamination.

    Ajouter un commentaire

    • Firmly lift the riser main slider with two hands.

    • Use caution not to drop the riser main, as this can damage the pump cylinder.

    Ajouter un commentaire

    • Use a pipe wrench to fully loosen the above grade riser pipe.

    Ajouter un commentaire

    • Lift the slider and riser main pipe.

    • Place a pump rod clamp around the rod, and tighten it securely against the pump rod.

    • Carefully lower the riser main and slider to allow it to rest on the rod clamp.

    Ajouter un commentaire

    • Loosen and remove both the pump rod jam nut and pump rod nut on the top of the slider.

    Ajouter un commentaire

    • Remove the riser main slider, and inspect it for wear and tear.

    • Set the slider in a sanitary place to prevent contamination.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jake Devincenzi

Membre depuis le 18/04/2011

106 610 Réputation

57 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 93