Introduction

Removing the grip is necessary to reach the battery door. This process is safe and easy.

Pièces

Aucune pièce nécessaire.

Remove the two 4.8 mm black screws above the lens on the front of the camera.
  • Remove the two 4.8 mm black screws above the lens on the front of the camera.

Ajouter un commentaire

Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.
  • Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.

Ajouter un commentaire

Remove the 4.8 mm black screw on the left side of the camera.
  • Remove the 4.8 mm black screw on the left side of the camera.

Ajouter un commentaire

Remove the front panel by lifting it away from the camera's body.
  • Remove the front panel by lifting it away from the camera's body.

Ajouter un commentaire

Slide the outer eyepiece upward to remove it.
  • Slide the outer eyepiece upward to remove it.

Ajouter un commentaire

Remove the two 4.75 mm black screws located  on the top of the camera.
  • Remove the two 4.75 mm black screws located on the top of the camera.

Ajouter un commentaire

Remove the four 4.3 mm  black screws near the bottom corners of the eyepiece at the back of the camera.
  • Remove the four 4.3 mm black screws near the bottom corners of the eyepiece at the back of the camera.

Ajouter un commentaire

Slowly separate the top panel from the camera by pushing it upward. Separating the top panel too far or quickly can damage the ribbon cable and connecting wires that are still attached to the top panel of the camera.
  • Slowly separate the top panel from the camera by pushing it upward.

  • Separating the top panel too far or quickly can damage the ribbon cable and connecting wires that are still attached to the top panel of the camera.

Ajouter un commentaire

Remove two 6.5 mm black screws from the panel.
  • Remove two 6.5 mm black screws from the panel.

Ajouter un commentaire

Remove the plastic remote control socket cap by pulling it straight out.
  • Remove the plastic remote control socket cap by pulling it straight out.

Ajouter un commentaire

Slide panel toward bottom of camera to remove. Slide panel toward bottom of camera to remove.
  • Slide panel toward bottom of camera to remove.

Ajouter un commentaire

Remove the two 5.5 mm screws from front of camera.
  • Remove the two 5.5 mm screws from front of camera.

Ajouter un commentaire

Remove grip panel.
  • Remove grip panel.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jackie

Membre depuis le 17/04/2011

218 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 8-8, Regan Spring 2011 Membre de l'équipe Cal Poly, Team 8-8, Regan Spring 2011

CPSU-REGAN-S11S8G8

5 membres

11 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 4

30 derniers jours : 18

Total : 2,821