Annuler

Canon PowerShot SD1100 IS Function Buttons Replacement

Rédigé par : Wyatt Chan (et 4 autres contributeurs)

Commentaires : 2
Favoris : 0

Canon PowerShot SD1100 IS Function Buttons Replacement

Difficulté

Modérée

Étapes

12

Temps nécessaire

20 minutes

Introduction

This guide should be used if our guide, "Cleaning Function Buttons", doesn't fix your function buttons.

Outils

Acheter ces outils

Spudger

2,99 $US

Acheter
Tweezers

4,99 $US

Acheter

Pièces

Aucune pièce nécessaire.

Étape 1 Front and Rear Cover

Remove wrist strap and battery.

Remove wrist strap and battery.

Étape 2

Remove 2 screws from each side of the camera (4 total, 0.102 in).

Remove 2 screws from each side of the camera (4 total, 0.102 in).
Remove 2 screws from the bottom on the camera (0.138 in).
Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.

Étape 3

Gently pull off the front cover.
The plate on the side should come off.
Gently pull off the back cover.

Étape 4

The cases should now be removed.

This can be a bit tricky when reassembling. All of the little tabs around the edge need to snap into their proper places, and there are three cover pieces to manage. Plus, you need to make sure that the camera/video/playback switch is properly engaged with its slider on the circuit board, otherwise you'll need to raise the back panel and reposition everything again.

Craig Bonsignore - 10/09/2011 Réponse

oh yes , i agree lol

elbala80 - 09/03/2016

Étape 5 Top Button Assembly

Use the spudger to disconnect the black tab.

Étape 6

Gently pull off the shutter button assembly.

Étape 7

Use the tweezers to disconnect the microphone cable.

Étape 8

The shutter button assembly should now be removed.

Étape 9 Function Buttons

With the spudger, flip up the black tab on the main ribbon.

Étape 10

Gently pull straight out on the ribbon to disconnect it from the logic board.

Étape 11

By hand, gently unfold the function button board and lift it off the frame.

Étape 12

Congratulations! The function button board can now be replaced.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 4 autres contributeurs

Wyatt Chan

Membre depuis le 05/01/2011

235 Réputation

2 tutoriels rédigés

+ 2 badges supplémentaires

Équipe

Cal Poly, Team 3-32, Regan Winter 2011 Membre de l'équipe Cal Poly, Team 3-32, Regan Winter 2011

CPSU-REGAN-W11S3G32

3 membres

8 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,791