Compaq Mini 110 Screen Replacement

alea et 6 autres contributeurs

Dernière mise à jour le June 10, 2022

5 minutes

Modérée

Étapes manquantes

Photos d’action

Meilleure introduction

Introduction

Passez à l'étape 1

Maybe it's cracked. Maybe you brought a magnet too close to it. Either way, the screen needs replacing and here's how to do it.

Ce dont vous avez besoin

Outils

Étape 1 Battery

Compaq Mini 110 Screen Replacement, Battery: étape 1, image 1 de 2

Compaq Mini 110 Screen Replacement, Battery: étape 1, image 2 de 2

Locate the battery and the battery tabs on the bottom of the Compaq Mini.

Traduire

Étape 2

Compaq Mini 110 Screen Replacement: étape 2, image 3 de 3

Push both tabs inward simultaneously and slide the battery out.

Traduire

Étape 3 RAM

Compaq Mini 110 Screen Replacement, RAM: étape 3, image 1 de 2

Compaq Mini 110 Screen Replacement, RAM: étape 3, image 2 de 2

Use a Philips #0 screwdriver to unscrew the two screws covering the memory compartment on the bottom of the laptop and remove the cover.

Traduire

Étape 4

Push out the side tabs simultaneously and pull out the old RAM module.
When inserting a new RAM stick, be sure to evenly insert the gold pins in the same orientation that the old module was removed. While sliding the module in, press the side tabs in place.

Traduire

Étape 5 Keyboard

Compaq Mini 110 Screen Replacement, Keyboard: étape 5, image 1 de 2

Compaq Mini 110 Screen Replacement, Keyboard: étape 5, image 2 de 2

Remove the rubber pads located on the corners of your Compaq Mini.
There may be junk underneath it. This is residue left from the glue that held on the rubber pad. Just scrape it away to find the screw.

Traduire

Étape 6

Unscrew all the corner screws. There are four total, one under each rubber pad.

Traduire

Étape 7

Unscrew the screw for the bottom case located in the RAM compartment.

Traduire

Étape 8

Remove the three screws in the silver tabs at the back of the keyboard.
These are located at the back of the base under the screen.
Lift the keyboard away from the laptop.

Traduire

Étape 9 Hard Drive

Compaq Mini 110 Screen Replacement, Hard Drive: étape 9, image 1 de 1

Remove the three screws holding the panel in place.

Traduire

Étape 10

Pull up on the tab to remove the hard drive.

Traduire

Étape 11 Top Cover

Compaq Mini 110 Screen Replacement, Top Cover: étape 11, image 1 de 1

Remove the eight screws that are from the plastic top cover.

Traduire

Étape 12

Compaq Mini 110 Screen Replacement: étape 12, image 3 de 3

Pry up the top plastic cover using a spudger.
These two tabs under the screen need to be pushed in with a spudger.

Traduire

Étape 13

Remove the cable by carefully pulling it up.
Be careful when lifting up the cover because the track pad is still attached.

Traduire

Étape 14 Display Assembly

Compaq Mini 110 Screen Replacement, Display Assembly: étape 14, image 1 de 3

Compaq Mini 110 Screen Replacement, Display Assembly: étape 14, image 2 de 3

Compaq Mini 110 Screen Replacement, Display Assembly: étape 14, image 3 de 3

Remove the four screws that keep the bottom of the hinges attached to the base.

Traduire

Étape 15

Compaq Mini 110 Screen Replacement: étape 15, image 3 de 3

Pry off the top plastic cover of the display assembly.
The spudger may go all the way through to the screen-side of the cover. This is not a problem and won't damage anything.
There is adhesive tape holding the cover on.

Traduire

Étape 16 Screen

Compaq Mini 110 Screen Replacement, Screen: étape 16, image 1 de 3

Compaq Mini 110 Screen Replacement, Screen: étape 16, image 2 de 3

Compaq Mini 110 Screen Replacement, Screen: étape 16, image 3 de 3

Remove the 4 screws keeping the screen on the plastic assembly.

Traduire

Étape 17

Compaq Mini 110 Screen Replacement: étape 17, image 3 de 3

Take the screen off the metal connectors by unscrewing each side. Each side has 2 screws.
The last picture shows the metal connectors that attach it to the display assembly.

Traduire

Étape 18

Compaq Mini 110 Screen Replacement: étape 18, image 3 de 3

Detach the cable from the screen. It is connected under the foil flap.
The large wire on the back of the screen is for both the webcam and the microphone, as well as the screen.

Traduire