Dell Inspiron 14 3465 Base Cover Replacement
Introduction
Passez à l'étape 1How To Remove And Replace The Base Cover
Ce dont vous avez besoin
Outils
-
-
Remove the eight screws (M2.5x8) that secure the base cover to the palm-rest assembly.
-
-
-
Remove the two screws (M2x5) that secure the base cover to the palm-rest assembly.
-
-
-
Remove the three screws (M2x2) that secure the base cover to the palm-rest assembly.
-
-
-
Remove the three screws (M2x5) that secure the base cover to the palm-rest assembly.
-
-
-
Open the latch, and disconnect the optical-drive cable from the system board.
-
-
-
-
Using a plastic scribe, pry the base cover off the palm-rest assembly.
-
-
-
Release the optical-drive interposer from the tabs, and remove it from the base cover.
-
-
-
Slide the optical-drive interposer into the tabs on the NEW base cover and snap it into place.
-
-
-
Place the base cover on the palm-rest assembly and route the optical-drive cable through the slot on the palm-rest assembly.
-
-
-
Slide the tabs on the base cover into the slots on the palm-rest assembly, and snap the base cover into place.
-
-
-
Slide the optical-drive cable into the connector on the system board and press down the latch to secure the cable.
-
-
-
Replace the three screws (M2x5) that secure the base cover to the palm-rest assembly.
-
-
-
Replace the three screws (M2x2) that secure the base cover to the palm-rest assembly.
-
-
-
Replace the two screws (M2x5) that secure the base cover to the palm-rest assembly.
-
-
-
Replace the eight screws (M2.5x8) that secure the base cover to the palm-rest assembly
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.