Etekcity Lasergrip 1080 Screen Replacement

Dernière mise à jour le January 25, 2016

5 minutes

Modérée

Introduction

This guide will show you how to replace a faulty screen. This will use a screwdriver and a plastic opening tool. There are no hazards involved with this guide.

Ce dont vous avez besoin

Outils

Afficher plus…

Étape 1 Battery

Etekcity Lasergrip 1080 Screen Replacement, Battery: étape 1, image 1 de 1

Pull the battery cover away from the handle by gripping near the thumb groove.

Traduire

Étape 2

Gently pull the battery out of the handle.
Excessive force could damage wires.

Traduire

Étape 3

Disconnect the battery by pulling the connector away from it.
Positive first
Negative second
When replacing the battery, this order is reversed.

Traduire

Étape 4 Buttons

Etekcity Lasergrip 1080 Screen Replacement, Buttons: étape 4, image 1 de 2

Etekcity Lasergrip 1080 Screen Replacement, Buttons: étape 4, image 2 de 2

Remove the battery cover from the device by pulling it straight out.

Traduire

Étape 5

Using the plastic opening tool remove the front and rear yellow covers.
When removing the back cover, be careful not to lose the buttons as they are not connected.

Traduire

Étape 6

Remove the two 3.1 mm Phillips #0 screws.

Traduire

Étape 7

Pull the two halves apart.
Be careful not to lose any components on the inside.

Traduire

Étape 8

Realign the buttons with the button terminals.
Red terminal to red button.
Orange terminal to orange button.
Yellow terminal to yellow button.

Traduire

Étape 9 Etekcity Lasergrip 1080 Trigger Replacement

Etekcity Lasergrip 1080 Screen Replacement, Etekcity Lasergrip 1080 Trigger Replacement: étape 9, image 1 de 2

Etekcity Lasergrip 1080 Screen Replacement, Etekcity Lasergrip 1080 Trigger Replacement: étape 9, image 2 de 2

Carefully pull the trigger out.
The trigger is spring loaded, so be careful that you do not lose the spring as you pull the trigger out.
To put the trigger back in, align the peg with the hole in the handle and align the shaft with the button terminal.