Mac mini Mid 2011 Logic Board Replacement

Dernière mise à jour le November 19, 2021

Aucune estimation

Modérée

Conditions préalables uniquement

Ce tutoriel est uniquement destiné à être utilisé comme prérequis d'autres tutoriels. Il ne se suffit pas à lui-même.

Introduction

Prerequisite only.

Outils

Afficher plus…

Use the flat end of a spudger to pry the hard drive connector up from its socket on the logic board.

Use the tip of a spudger to lift the IR sensor connector up and out of its socket on the logic board.
Make sure to pry up from beneath the wires and not underneath the socket.

Outil utilisé dans cette étape :

Mac mini Logic Board Removal Tool

$4.99

To remove the logic board, the two cylindrical rods of the Mac mini Logic Board Removal Tool must be inserted into the holes highlighted in red. Inserting instruments into any logic board holes other than the ones highlighted in red may destroy the logic board.
Insert the Mac mini Logic Board Removal Tool into the two holes highlighted in red. Be sure it makes contact with the top side of outer case below the logic board before proceeding.
Carefully pull the tool toward the I/O board. The logic board and I/O board assembly should slightly slide out of the outer case.
Cease prying when the I/O board is visibly separated from the outer case.
Remove the Mac mini Logic Board Removal tool.

Pull the I/O board/logic board assembly out of the outer case enough to access the power connector.
Use your fingers to disconnect the DC-In cable from the logic board.
Pull the power cable connector toward the front side of the mini.