SONY ZS-BTG900 Subwoofer Replacement

Alfredo Rodriguez et 4 autres contributeurs

Dernière mise à jour le January 3, 2019

10 - 15 minutes

Modérée

Tutoriel étudiant vedette

Introduction

Passez à l'étape 1

Subwoofers are notorious for blowing out. Consistent use at low frequencies result in a short life span for these parts.

This guide will show you how to replace the subwoofer instead of having to throw out you entire device. A replacement subwoofer can be found online or salvaged from another device.

Ce dont vous avez besoin

Outils

Afficher plus…

iFixit touche une commission lorsque vous achetez par l'intermédiaire de ces liens.

Étape 1 SONY ZS-BTG900 Disassembly

SONY ZS-BTG900 Subwoofer Replacement, SONY ZS-BTG900 Disassembly: étape 1, image 1 de 2

SONY ZS-BTG900 Subwoofer Replacement, SONY ZS-BTG900 Disassembly: étape 1, image 2 de 2

Lift up the handle to reveal the screws.
Use your Phillips #2 screwdriver to remove the eight 1/2 inch screws.

Traduire

Étape 2

SONY ZS-BTG900 Subwoofer Replacement: étape 2, image 3 de 3

Flip your device over.
Use your Phillips #2 screwdriver to remove the six 3/4inch screws.
In removing the screws within the two holes on the back of the device, you may want to use your shaft extension to provide extra torque as they may be very tight.

Traduire

Étape 3

Flip your device back over to access the top of the device.
Use your plastic opening tool to pry up and remove the panel on the top, left hand side of the device.
This will reveal two additional screws.

Traduire

Étape 4

Use your Phillips #2 screwdriver to remove the two 1/2 inch screws underneath the now-removed panels.

Traduire

Étape 5

Lift off the top, beginning from the back of the device.
Take care when lifting the top portion as there are many wires connected to the inside of the device and you do not want to disconnect these just yet.

Traduire

Étape 6

Disconnect the CD drive ribbon cable from the top of the device.

Traduire

Étape 7

Disconnect the antenna cables.

Traduire

Étape 8

SONY ZS-BTG900 Subwoofer Replacement: étape 8, image 3 de 3

Disconnect the remaining cables from the motherboard.

Traduire

Étape 9

Once you have removed the top, we will begin removing the front of the device.
Begin by disconnecting the 6 cables that lead from the front of the device to the motherboard.

Traduire

Étape 10

Use your Philips #2 screwdriver to remove the two 1 inch screws on the outermost part of the device.
Use your Philips #2 screwdriver to remove the two 3/4 inch screws on the outermost part of the device.
Use your Philips #2 screwdriver to remove the one 5/6 inch screw on the middle part of the device.

Traduire

Étape 11

Firmly pull off the front of device.
There will be a small amount of black glue. You can simply ignore this, and continue to pull, or use a sharp edge to cut the glue once you've revealed it.

Traduire