The screws from the camera are extremely small so it is a good idea to have a small container to hold all the screws as you remove them.
  • The screws from the camera are extremely small so it is a good idea to have a small container to hold all the screws as you remove them.

Ajouter un commentaire

Take your screwdriver and remove the bottom screws of the camera. (The picture shows the lens facing away from you and the LCD facing you.) There should be four silver screws.
  • Take your screwdriver and remove the bottom screws of the camera. (The picture shows the lens facing away from you and the LCD facing you.) There should be four silver screws.

Ajouter un commentaire

  • On the right side of the camera, remove the two screws using the screwdriver. There will be two silver screws. (The picture shows the lens facing away from you and LCD screen facing you.)

Ajouter un commentaire

  • On the left side of the camera, remove the two screws using the screwdriver. There will be two silver screws. (The picture shows the lens facing away from you and the LCD screen facing you.)

Ajouter un commentaire

  • Gently remove the back casing by holding onto both sides of the camera and pulling them apart.

Ajouter un commentaire

  • Now, carefully pull off the back cover.

Ajouter un commentaire

  • The two halves of the camera casing should now be separate.

Ajouter un commentaire

  • Keep track of the small screws that you remove.

  • Opening, removing and/or replacing the front casing may void your manufacturers warranty

Ajouter un commentaire

  • Remove the two screws at the top of the camera casing.

There was no screw in the left hand location shown, when disassembling my camera for the first time.

Chas - Réponse

  • Gently pop open the plastic piece as shown.

Ajouter un commentaire

  • Remove the screw connecting the front casing to the electrical components as shown.

Ajouter un commentaire

  • Gently loosen and remove the side casing by firmly pulling with your fingers.

  • Take care not to break the fragile part or to scratch the LCD screen.

Ajouter un commentaire

  • Remove the two screws connecting the front casing to the electrical components.

Ajouter un commentaire

  • Gently loosen the front casing.

  • Be careful not to scratch any of the exposed electrical components.

Ajouter un commentaire

  • Fully remove the front casing from the camera.

Ajouter un commentaire

Ajouter un commentaire

  • Remove the two silver screws and two black screw holding the image sensor in place.

Ajouter un commentaire

  • Using a spudger, wedge the flat tipped end between the black bar and the circuit board.

  • Carefully lift the black bar into the vertical position.

  • Repeat first two bullet points for the circuit board port directly to the left of the one shown in this picture.

  • Use tweezers to carefully pull the electrical ribbons from the circuit board ports.

Ajouter un commentaire

  • Carefully remove image sensor and replace with new image sensor.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

iRobot

Membre depuis le 24/09/2009

1 Réputation

774 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 5,226