Surfboard Futures Fin Replacement

Dernière mise à jour le February 20, 2024

5 minutes

Facile

Introduction

Does your surfboard have a broken or loose fin? This guide will help you replace your Futures surfboard fin to get you back on the water in no time!

Ce dont vous avez besoin

Pièces

Surfboard Fin
Lien d'affiliation
Disponible à la vente sur Amazon
Afficher

Outils

Surfboard Fin Key
Lien d'affiliation
Disponible à la vente sur Amazon
Afficher

Afficher plus…

iFixit touche une commission lorsque vous achetez par l'intermédiaire de ces liens.

Étape 1 Futures Fin

Surfboard Futures Fin Replacement, Futures Fin: étape 1, image 1 de 3

Surfboard Futures Fin Replacement, Futures Fin: étape 1, image 2 de 3

Surfboard Futures Fin Replacement, Futures Fin: étape 1, image 3 de 3

Lay your surfboard down on a flat, durable surface long enough to support the length of your board.

Traduire

Étape 2

Surfboard Futures Fin Replacement: étape 2, image 3 de 3

Make sure the small screw hole in front of the fin is free of debris and sand.
Insert the key into the hole and begin turning counter-clockwise to loosen the screw inside.

Traduire

Étape 3

Continue turning counter-clockwise until the screw is free.

Traduire

Étape 4

Surfboard Futures Fin Replacement: étape 4, image 3 de 3

Firmly grasp the fin with one hand and place your other hand on the surfboard for stabilization.
Simultaneously lift the fin while tilting it backwards to remove the fin.

Traduire

Étape 5

Notice the circular inlet on the rear bottom side of the fin. This inlet of the fin fits snuggly into the little rod located in the back of the fin slit on the board, much like a puzzle.

Traduire

Étape 6

Surfboard Futures Fin Replacement: étape 6, image 3 de 3

With your new or repaired fin, insert the back in first so that you feel the inlet on the fin clip into the little rod in the slit.
Once you feel the back secure, bring the front of the fin down into the slit.

Traduire

Étape 7

Surfboard Futures Fin Replacement: étape 7, image 3 de 3

Place the screw back into the hole and begin turning clockwise using the key.
Continue turning until the screw is tight and won't turn any more.
Once the screw stops turning, do not continue to tighten or you may damage the screw or fin.