/
Mon établi

Accédez rapidement aux tutoriels, aux pièces et aux réponses correspondant à vos appareils

DE
Deutsch
ES
Español
IT
Italiano
PT
Português
TR
Türkçe
JP
日本語
EN
English
FR
Français
NL
Nederlands
RU
Pусский
ZH
中文
KO
한국어
S'inscrire
Connexion

Historique de l'introduction : Kinetec Spectra S1 Hand Controller Keypad Replacement

Modifié par Al Johnson —

Modification approuvée par Al Johnson

Avant
Après
Inchangé
Appareil
Kinetec Spectra S1
Type
replacement
Thing
Hand Controller Keypad
Title
Kinetec Spectra S1 Hand Controller Keypad Replacement
Introduction
***Instructions for Replacing the Lower Keypad on the Kinetec Spectra / Essential Hand Controller***
***Step 1: Open the hand controller by removing all eight Pozi-drive screws from the rear side (not Phillips, but a Phillips screwdriver will work if you are careful).***
***A.     If you are patient enough usually this can be done without disturbing the rubber around the hand controller. Otherwise, you can rip off the entire rubber cover and re-attach later using super glue or E6000 Quick Hold glue. It is recommended to keep the rubber intact.***
***B.     Then unscrew the gland at the base of the hand controller to allow the cable to move freely***
***C.     Once this has been done, both sections of the hand controller can be separated.***
***D.     Then the old keypad can be removed by first sliding the locking mechanism on the flex cable (see Figure 2 & Figure 3) and then prying off the old keypad from the front.***
***E.      Once the old keypad is removed there may be old glue left on the front. This can be carefully scrapped away using something like a plastic spudger tool or a plastic sticker remover.***
 ******
***Step 2: Remove the sticky backing of the new keypad and slide the ribbon cable through the cable hole in the front cover.***
***Step 3: Press around the edges of the keypad and around all the buttons once secured.***
***Step 4: Reverse the order of Step 1, BUT BE VERY CAREFUL NOT TO SMASH THE RIBBON CABLE BETWEEN THE FRONT AND REAR COVERS. It is helpful to angle the front cover while assembling the two case pieces back together and looking between them for any sign of a pinched ribbon cable before replacing the screws in the hand controller.***
***Step 5: reassembly the gland on the cable and you are done.***
***TIP:*** Make sure you do not accidentally bump or flip this switch. Make sure it is set to ON / FLASH memory instead of REMOTE / OFF . If this switch has been accidentally flipped the hand controller will display SERV. MODE or Service Mode on the LCD screen.
 
Replacement keypads can often be found on eBay for a good price.
Time Required Min
Aucune estimation
Time Required Max
Aucune estimation
Imageid
Avant
Après
Difficulty
Moderate
Conclusion
To reassemble your device, follow these instructions in reverse order.
Author
Al Johnson
Public
Non

Drapeaux

  • In Progress added.
  • Community-Contributed Guide added.

Étapes

Étape n° 1
Avant
Après
stepid 391393 stepid 391393