Historique de l'étape n° 19 de Canon PowerShot S100 Lens Assembly Replacement

	[title] Optional: Install CCD on Replacement Lens Assembly
	[* black] If your replacement lens assembly does not include a CCD (sensor), you can swap the CCD from the old lens assembly to the new one.
	[* black] Carefully scrape 5 glue dots from edges of CCD on old lens assembly. Note that photo is of a different camera & screw numbering is different; also, this would be done before lens assembly is installed.
-	[* black] Remove 3 screws securing CCD to back of lens assembly and remove CCD, noting any tiny brass washers/spacers that may be present where screws were.
-	[* black] Remove rubber infrared filter gasket and infrared filter (small rectangle of bluish glass) from back of old lens assembly) & install on back of new lens assembly.
+	[* black] Remove 3 screws securing CCD to back of lens assembly and remove CCD, noting any tiny brass washers/spacers that may be present where screws were. Remove CCD, being careful not to touch or get dust on sensor surface.
+	[* black] Remove rubber infrared filter gasket and infrared filter (small rectangle of bluish glass) from back of old lens assembly & install on back of new lens assembly.
	[* black] Install CCD on back of new lens assembly (may or may not need to use brass washers to get alignment right for correct focus).
	[* black] Note: S100 & S110 CCDs are not interchangeable - ribbon connector for the S100 lens assembly is larger, & does not fit on the S110 board connector.