Modifications apportées à l'étape #5
Modifié par Adam O'Camb —
Modification approuvée par Adam O'Camb
- Avant
- Après
- Inchangé
Lignes de l'étape
| - | [* icon_note] If your part did not come with pre-cut adhesive, use high-bond double |
|---|---|
| + | [* icon_note] If your part did not come with pre-cut adhesive, use high-bond double-sided tape, such as [product|IF317-072-1|Tesa 61395|new_window=true], or pieces of a [guide|113604|pre-cut adhesive sheet|new_window=true] to secure the camera bezel. |
| [* black] Cut pieces of tape to the appropriate size so they fit along the edges of the camera bezel. | |
| [* icon_note] Measure the areas you want to apply tape to, and then mark those measurements on the tape with a pen to make sure each piece is the proper length and width. When in doubt, use a narrower size tape than you think you might need. | |
| [* black] Use tweezers to apply the tape to the metal surface of the bezel, on the side where the camera lens cover protrudes. | |
| [* black] Try to cover most of the metal surface of the bezel with tape. Avoid overlapping tape onto any plastic or glass areas. |