Modifications apportées à l'étape #2
Modifié par gaurav patankar —
Modification approuvée par gaurav patankar
- Avant
- Après
- Inchangé
Lignes de l'étape
| [title] Adjusting Product Drive | |
| [* black] ***Product Drive:*** Product Infeed occurs on a dual timing belt-based pulley drive. On top of this belt drive, chain mounting adapters are provided, where product partition plastic pockets are press fit as shown in the diagram below. It moves products in pocket from feeding station to the loading station. | |
| - | [* black] Based on the product width the pockets must be adjusted with the help of the following steps: 1.Loosen the bolts as shown in green circles above & Increase the gap by rotating the pulley in direction as shown by the arrow and Vice versa. 2.Place the product in pocket to verify the gap and ensure that there are few 1-2mm moving spaces. |
| + | [* black] Based on the product width the pockets must be adjusted with the help of the following steps: |
| + | [* black] Loosen the bolts as shown in green circles above & Increase the gap by rotating the pulley in direction as shown by the arrow and Vice versa. |
| + | [* black] Place the product in pocket to verify the gap and ensure that there are few 1-2mm moving spaces. |