Modifications apportées à l'étape #11
Modifié par Ben Moores —
Modification approuvée par Ben Moores
- Avant
- Après
- Inchangé
Lignes de l'étape
| + | [title] Remove Landscape-Portrait Ring |
|---|---|
| + | [* black] Using a PH0 Screwdriver remove the three silver screws in the middle ring of screws. |
| + | [* icon_caution] Do not remove any of the 3 black screws in the recessed holes or the 3 silver screws nearest the back lens. |
| + | [* black] Lift the orientation ring. There are some felt pads on the lower lip that make it a little stiff, but it will lift out. |
| + | [* icon_caution] Note that one of the FPC is connected to the orientation ring. |
| + | [* icon_caution] Note that one of the plastic tabs has an orientation pillar that fits into the small hole near one of the screws. |
| + | [* icon_caution] Be very careful if you disassemble the orientation ring. There is a sping loaded detent roller that is difficult to re-fit. |
| + | [* black] Screws: 3@ M1.5 x 4mm (white threadlock) |
| + | [* black] FPC Marking: XL1406_FPC_ENCODER_FPC_Rev03 UFK144513 |
Image 1
Aucune image précédente
Ajouté
Image 2
Aucune image précédente
Ajouté
Image 3
Aucune image précédente
Ajouté