Modifications apportées à l'étape #89
Modifié par robertcbaruch —
Modification approuvée par robertcbaruch
- Avant
- Après
- Inchangé
Lignes de l'étape
| + | [* black] Take the part over to the arbor press. |
|---|---|
| + | [* black] You must support the part against something that will provide maximum surface area to the part, but also allow the taper pin to move at the bottom. |
| + | [* black] A piece of aluminum with a semicircular depression is perfect. You can do this either with a drill, then sawing off halfway through the diameter of the hole, or with an endmill of the right diameter. |
| + | [* black] Then cut a smaller notch the length of the depression to allow the pin to move. Again, this could be done with a drill and a saw, or an endmill. |
Image 1
Aucune image précédente
Ajouté