Historique de l'étape n° 6 de Canon Powershot A720 IS Lens Replacement

-	[* black] Carefully lift and turnover the LCD Screen so ~~that~~ you are able to see the motherboard.
-	[* icon_caution] ~~Treat~~ the ~~motherboard with care since~~ it ~~is very sensitive to static discharge. Remain grounded to avoid the~~ release of static discharge ~~by wearing a static bracelet~~.
-	[* red] ~~Carefully disconnect~~ the LCD Screen ribbon ~~cable away from its ZIF connector~~ with your thumb and index finger. ~~You must make sure to have~~ your ~~thumb and index finger cover as much of the ribbon's width and as~~ close to the ZIF connector ~~as possible without touching the motherboard while~~ pulling the ribbon out.
-	[* ~~icon_caution~~] ~~Be careful to~~ not rip the ribbon wire or the red and black power wires when pulling the LCD screen out.
-	[* icon_note] You do not have unsolder ~~the~~ the LCD screen if you are only replacing the lens.
+	[* black] Carefully lift and turnover the LCD Screen so you are able to see the motherboard.
+	[* icon_caution] Be very careful with the LCD Screen and avoid wearing a static bracelet as it will cause release of static discharge.
+	[* red] Without touching the motherboard, grab the LCD Screen's ribbon wire with your thumb and index finger and carefully disconnect it from the ZIF connector. Have your fingers close to the ZIF connector when pulling the ribbon wire out. The LCD Screen should be positioned in between your fingers.
+	[* black] Do not rip the ribbon wire or the red and black power wires when pulling the LCD screen out.
+	[* icon_note] You do not have to unsolder the LCD screen if you are only replacing the lens.