Historique de l'étape n° 5 de Canon Powershot SD750 Motherboard Replacement

-	[* red] Remove the two 3.46 mm ~~Philip's~~ screws connecting the logic board to the frame of the camera.
-	[* icon_note] The heads of these two screws are completely flat,while most of the other screws found within this camera have a rounded head.
-	[* yellow] Disconnect the ribbon at the bottom of the main board~~, as indicated in the picture,~~ by ~~rotating~~ the brown connector ~~upwards~~ and ~~pulling~~ the ribbon out.
-	[* blue] If the flash is not removed, remove the right most square connector at the bottom of the camera~~. Grab~~ the connector with two fingers ~~and pull upwards till~~ it detaches.
-	[* ~~icon_note~~] Do not lose the white rubber cover ~~indicated by the purple square in the image. This is~~ for the microphone.
+	[* red] Remove the two silver 3.46 mm Philips screws connecting the logic board to the frame of the camera.
+	[* icon_note] The heads of these two screws are completely flat, while most of the other screws found within this camera have a rounded head.
+	[* yellow] Disconnect the ribbon at the bottom of the main board by flipping up the brown ZIF connector and sliding the ribbon out.
+	[* blue] If the flash is not removed, remove the right most square connector at the bottom of the camera by flipping up the connector with two fingers until it detaches.
+	[* violet] Do not lose the white rubber cover for the microphone.