Modifications apportées à l'étape #1
Modifié par Ben Eisenman —
- Avant
- Après
- Inchangé
Lignes de l'étape
| - | [* black] Use a small iPod opening tool to release the black hinge holding the hard drive ribbon cable. |
|---|---|
| + | [* black] Use a small iPod opening tool to release the black hinge holding the hard drive ribbon cable. The tab will rotate up 90 degrees towards the logic board, releasing the ribbon cable. |
| [* black] Use your forefinger to hold the ribbon cable in place; disconnect the drive from the ribbon cable. | |
| [* icon_note] Make sure the hard drive rubber side bumpers are attached to the drive being installed. Use the hard drive rubber side bumper installation guide to accomplish this task. | |
| [* icon_note] If necessary, the blue foam padding on the hard drive might also need to be transferred to the replacement drive. |