Modifications apportées à l'étape #2
Modifié par Bas Flipsen —
Modification approuvée par Bas Flipsen
- Avant
- Après
- Inchangé
Lignes de l'étape
| [title] get the knife set out of the casing | |
| [* black] When you look at this component, you will see four Torx T3 screws. Leave them for later and get to the other side. | |
| - | [* black] Get an 8 wrench and something to grip the other side. I used pliers for this (see photo for the tools). To loosen the bolt you have to turn it to the right (instead of normally to the left). |
| + | [* black] Get an 8 wrench and something to hold the other side. I used a pipe wrench for this, but you can use any other plier for it (see photo for the tools). To loosen the bolt you have to turn it to the right (again unexpected, must be something Swiss ;). |
| + | [* black] If all went well you can now take all three knifes off and you will see a metal washer and underneath a rubber bushing. |