Historique de l'étape n° 4 de iPod Touch 2nd Generation Battery Replacement

	[* red] The battery on the iPod Touch is attached via solder pads.
-	[* black] Heat the of the solder pads individually and use your metal spudger to pry it from the logic board.
+	[* black] Heat the solder of the solder pads individually and use your metal spudger to pry them from the logic board.
+	[* black] When soldering, work from one side of the ribbon cable. Heat the side while using the spudger to gently lift the ribbon cable from the board. Repeat this process for the other two pads.
	[* icon_caution] Only solder the solder pads on the board and the ribbon cable. Soldering outside the correct area has potential to ruin the logic board.
	[* icon_caution] Make sure to only hold the tip of the iron against the solder pad long enough to complete the melt. Overheating can ruin the logic board and the ribbon cable.
-	[* black] When soldering, work from one side of the ribbon cable. Heat the side while using the spudger to gently lift the ribbon cable from the board. Repeat this process for the other two pads.