Traduction de l’étape 7
Étape 7
Take off the casing
-
Remove the right main control board module by hand vertically upwards, this control board is removed from the charging control board below.
-
Let's remember where each wire is connected.
-
Connect to the top control board
-
Bluetooth signal cable
-
Front and back paper cone full-range speaker connections. Note: The control panel is labeled "REAR" (2pin) and "FRONT" (3pin).
-
Thin Series Wooferconnect(2pin)
-
Cables for connecting the battery
Vos contributions sont faites dans le cadre de la licence open source Creative Commons.