Info : Vous modifiez un tutoriel prérequis. Toutes les modifications apportées affecteront les 4 tutoriels qui comprennent cette étape.
Traduction de l’étape 3
Étape 3
-
Lay the X10 on its back so that the bottom is facing you.
-
Using the metal spudger, separate the two connection points located on the left and right sides of the mesh panel as shown.
-
Separate the connection point in the center of the bottom section of the device.
-
As before, all connection points should audibly 'pop' when disconnected, and the mesh panel will visibly separate from the body of the X10.
Vos contributions sont faites dans le cadre de la licence open source Creative Commons.