Hota H6 Pro Battery Charger Disassembly & AC Fuse Replacement
2 heures
Modérée
Tutoriel réalisé par la communauté
Introduction
Passez à l'étape 1The Hota H6 Pro also sold as the Hobbymate Speed H6 Smart Charger and the Blue Robotics H6 PRO Lithium Battery Charger is a compact 200w AC/DC battery charger for various lithium and other battery chemistries up to a 6S balanced cell count.
This guide will show you how to:
- Disassemble the H6 Pro
- Replace the internal AC power fuses.
- This may be needed if AC input does not work, but the DC input does work.
- Due to the circuit design, the AC fuse is UNLIKELY to blow before other damage occurs so you'll probably need to do some digging to find if any other components are fried.
Ce dont vous avez besoin
Pièces
Outils
Afficher plus…
-
-
Insert a pick above the DC IN plug
-
Pry pick down to slightly raise the top plate above the body
-
-
-
-
The two fuses shown here can be Desoldered and replaced if needed.
-
Test the fuses by using a multimeter to probe the resistance between the pairs of pins (shown in green) on the underside of the circuit board. Working fuses should be near zero resistance. Broken fuses will show 'infinite' resistance.
-
Presque terminé !
Re-assemble in reverse order
Conclusion
Re-assemble in reverse order
