Aller au contenu principal

Reemplazo de la placa de escudo de LCD de iPad Mini 3 Wi-Fi LCD

Info : Vous modifiez un tutoriel prérequis. Toutes les modifications apportées affecteront les 16 tutoriels qui comprennent cette étape.

Anglais
Espagnol

Traduction de l’étape 20

Étape 20
iPad Mini 3 Wi-Fi LCD Shield Plate Replacement: étape 0, image 1 de 3 iPad Mini 3 Wi-Fi LCD Shield Plate Replacement: étape 0, image 2 de 3 iPad Mini 3 Wi-Fi LCD Shield Plate Replacement: étape 0, image 3 de 3
  • Slide the lower left pick to the lower left corner to cut the adhesive on that corner.

  • Leave the pick at the corner. Do not pry any farther, and do not remove the pick from the iPad.

  • There are quite a few things to avoid beneath the lower bezel, so study the third image closely:

  • Antennas

  • Home button cavity

  • Digitizer cable

  • The following steps will direct you where to pry to avoid damage to these components. Only apply heat and pry where directed.

Desliza la púa inferior izquierda hacia la esquina inferior izquierda para cortar el adhesivo de esa esquina.

Deja la púa en la esquina. No sigas haciendo palanca ni retires la púa del iPad.

Hay bastantes cosas que debes evitar debajo del bisel inferior, así que estudia detenidamente la tercera imagen:

Antenas

Cavidad del botón de inicio

Cable del digitalizador

Los siguientes pasos te indicarán dónde hacer palanca para evitar dañar estos componentes. Sólo aplica calor y haz palanca donde se te indique.

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.