Aller au contenu principal

Info : Vous modifiez un tutoriel prérequis. Toutes les modifications apportées affecteront les 3 tutoriels qui comprennent cette étape.

Anglais
Chinois

Traduction de l’étape 2

Étape 2
Remove the Home Button bracket and peel up the tape connected to it. During reassembly, after installing the home button, you'll need to glue this bracket into place to secure it Scrape off as much of the old adhesive residue from the bracket as you can, then clean it with acetone or high-concentration (90% or greater) isopropyl alcohol.
  • Remove the Home Button bracket and peel up the tape connected to it.

  • During reassembly, after installing the home button, you'll need to glue this bracket into place to secure it

  • Scrape off as much of the old adhesive residue from the bracket as you can, then clean it with acetone or high-concentration (90% or greater) isopropyl alcohol.

  • Secure the bracket with hot-melt glue, superglue, or high-strength double-sided tape. Make sure the bracket is aligned correctly before allowing your adhesive to cure, or the home button will not click when pressed.

移走Home键支架,并剥去连接其的胶带。

在重新组装的时候,安装Home键后,你需要将此支架粘合到位以固定它

尽可能多地刮掉支架上的旧粘合剂残留物,然后用丙酮或高浓度(90% 或更高)的异丙醇清洁它。

用热熔胶、强力胶或高强度双面胶带固定支架。 在让你的粘合剂固化之前,请确保支架正确对齐,否则按下Home键时不会发出咔嗒声。

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.